DNC and CNC setting for Mazak - M plus

Set the following parameters on the machine

Note:

The program does not support the Mazatrol protocol

Change user parameter #5
G1 (baud rate)	1 (9600)
G2 (stop bits)	3 (2 stop bits)
G3 (parity)	0 (Even)
G5 (data bits)	3 (8 data bits, but in the program you should specify 7 )
G6 (Terminattors)	1 (EOB or EOR)
G10	3 (Use DC handshaking)
G11	1 (Parity on DC output)
G12	0 (Don't output DC2 and DC4)
G13 (wait time)	50
G17	00000000
G31	00000000
G33 (feed section size)	50
G34 (number of spaces)	10
G39	00000100
G40	00000000
G48	0

Set the following parameters on the PC

Serial port tab

Machine name	Mazak - M plus
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	Both
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Mazak - Fusion 640T
Mazak - L32
Mazak - M32 plus
Mazak - M32
Mazak - T plus

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.