DNC and CNC setting for Mazak - L32

Set the following parameters on the machine

Note:

The program does not support the Mazatrol protocol

Change CNC parameters
FD I/O Mode	1 (ISO)
FD I/O STOP BIT	2 (2 bits)
FD I/O PARITY	0 (No Parity, but in DNCP you should use the Even parity)
FD I/O BAUD RATE	9600

Set the following parameters on the PC

Serial port tab

Machine name	Mazak - L32
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	Both
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: Yes Program ending characters in the file: Yes

Go to Index page
Mazak - Fusion 640M
Mazak - Fusion 640T
Mazak - M plus
Mazak - M32 plus
Mazak - M32

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.