DNC and CNC setting for Mazak - M32

Set the following parameters on the machine

Note:

The program does not support the Mazatrol protocol

Change user parameter #5
G19 (baud rate)	2 (4800)
G20 (stop bits)	3 (2 stop bits)
G22 (parity)	0 (Even)
G23 (data bits)	3 (8 data bits, but in the program you should specify 7 )
G24	1
G25	0
G26	0
G27 (ISO CR output)	0
G28	0
G29 (handshake type)	3

Set the following parameters on the PC

Serial port tab

Machine name	Mazak - M32
Serial port	COM2 (or any free COM port)
Baud	4800
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: : Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Mazak - M plus
Mazak - M32 plus
Mazak - T plus
Mazak - T2
Mazak - T32 M2

If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.