DNC and CNC setting for Hinumerik 3000T

Set the following parameters on the machine

411	11101101
412	11101101

Change following bits in the parameter #416 only
bit 7	1
bit 0	0

If you want, you can change baud rate (#411,#412)
Baud	Parameter value
1200	11101100
2400	11101101
4800	11101110
9600	11101111

Set the following parameters on the PC

Serial port tab

Machine name	Hinumerik 3000T
Serial port	COM2 (or any free COM port)
Baud	2400
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: Program end: Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Hinumerik 2100T
Hinumerik 3000M
Hitachi Seikos
Huller - Hille
Hurco - Ultimax

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.