DNC and CNC setting for Hinumerik 2100T

Set the following parameters on the machine

5010	0
5011	11000101
5012	0
5013	11000101
RTS line	1

Change following bits in the parameter #5016 only
bit 5	1
bit 4	0

If you want, you can change baud rate (#5011,#5013)
Baud	Parameter value
1200	11000100
2400	11000101
4800	11000110
9600	11000111

Set the following parameters on the PC

Serial port tab

Machine name	Hinumerik 2100T
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: Program end: Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Hinumerik 2000T
Hinumerik 2100M
Hinumerik 3000M
Hinumerik 3000T
Hitachi Seikos

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.