bg

DNC and CNC setting for Futaba CMC

These settings are for the DNC Precision software only. They may not work with other software.

Futaba CMC 320 - NC settings

Set the following parameters on the machine

P123 (ASCII mode)Bit 4 = 2
P124 (Data bits)7
P125 (Parity)2 (Even)
P126 (Stop bits)1 (One)
P127 (Baud rate)9600

Set the following parameters on the PC

Serial port tab

Machine nameFutaba CMC 320
Serial portCOM2 (or any free COM port)
Baud9600
Data bits7
ParityEven
Stop bits2

Data flow control tab

Use DTRFalse
Use RTSFalse
Require DSRFalse
Require CTSFalse
Set RTSTrue
Set DTRTrue
Software flowcontrolBoth
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start: %
Program end: %
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
 

Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
 

Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

Go to Index page
Fanuc O-T
Fanuc MSC-516
GE Mark Century 1050
GE Mark Century Plus

If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.