DNC and CNC setting for GE Mark Century
These settings are for the DNC Precision software only. They may not work with other software.
GE Mark Century 1050 - Machine parameters
Set the following parameters on the PC
Serial port tab
| Machine name | GE Mark Century 1050 |
| Serial port | COM2 (or any free COM port) |
| Baud | 2400 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | False |
| Use RTS | True |
| Require DSR | False |
| Require CTS | True |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | Both |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start:
Program end:
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No |
Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Go to Index page
Futaba CMC 320
Fanuc O-T
GE Mark Century Plus
Generic CNC machine
If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.
