DNC and CNC setting for Brother - TC-32 A

Set the following parameters on the machine

Select Port	0
Connection Object	0
Comp Communication Protocol	0 (ASCII)
Baud Rate	5 (9600)
Character	0 (7 data bits)
Parity	0 (None)
Stop Bit	0 (1)
Response Monitoring Time	60
Communication Type	0
DC1 Code	17
DC2 Code	18
DC3 Code	147
DC4 Code	20
DR Signal Check	0
Ending DC3 Code	0
Invalid Data	1
TRNAS Data Code	0
End of Block	1
TV Check	0
Heading Output	0
Reset in Slave Communication	0
Recovery Time of Reset	1
Data Overwrite	1
Remote Operation	1
Check Sum	0
EIA Character Code (#)	173
EIA Character Code (*)	186
EIA Character Code (=)	194
EIA Character Code ([)	161
EIA Character Code (])	162

Set the following parameters on the PC

Serial port tab

Machine name	Brother - TC-32 A
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	None
Stop bits	1

Data flow control tab

Use DTR	False
Use RTS	False
Require DSR	False
Require CTS	False
Set RTS	True
Set DTR	True
Software flowcontrol	None
Xon char	#11
Xoff char	#12

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: %% Program end: %% Line start: Line end: #0D#0A Skip lines: ; Ignore characters: No characters for remove Remove blank lines: Yes Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Bridgeport - Boss 8
Bridgeport - Boss 9
Burny 1400
Burny 2.5 CLINK
Burny 3

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.