DNC and CNC setting for Burny 3

Set the following parameters on the machine

Check the special protocols option in 'DSPY 80-CONFIGURE'
COMMUNICATION ENHANCEMENT OPTION	OFF

Permanently set all communication parameters in 'SD50-SERIAL DEFN' (see the 'INSTALL' section in your machine user manual)
PROTCL	2 (XON/XOFF)
PGM TYPE	1 = (Standard Burny 3 word address program)
CHAR TYPE	5 (OP7D-ASCII, Odd parity, 7 data bits)
BAUD RATE	2400

Set the following parameters on the PC

Serial port tab

Machine name	Burny 3
Serial port	COM2 (or any free COM port)
Baud	2400
Data bits	7
Parity	Odd
Stop bits	1

Data flow control tab

Use DTR	False
Use RTS	False
Require DSR	False
Require CTS	False
Set RTS	True
Set DTR	True
Software flowcontrol	Both
Xon char	#14
Xoff char	#12

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: %% Program end: %% Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: Yes Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Burny 1400
Burny 2.5 CLINK
Cincinatti Milacron - Acramatic 850-SX
Conquest CNC
DOOSAN HM630

If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.