DNC and CNC setting for Traub - Traub system TX-8-k

Set the following parameters on the machine

Preparation data #1
01 (parity)	0
04 (ISO/EIA output)	1

Preparation data #2
12 (baud rate)	5 (2400)

Set the following parameters on the PC

Serial port tab

Machine name	Traub - Traub system TX-8-k
Serial port	COM2 (or any free COM port)
Baud	2400
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: Program end: Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Takumi V8, V11 - Vertical machining center
Tanaka
Victor Taichung - H630
Victor Taichung - V105
Victor Taichung - V630

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.