DNC and CNC setting for Siemens - Sinumerik 840D
These settings are for the DNC Precision software only. They may not work with other software.
Set the following parameters on the machine
Serial | 1 |
Device | Standard |
Device type | Universal |
Protocol | RTS/CTS (Hardware) |
Baud rate | 9600 |
Stop bits | 2 |
Parity | Even |
Bits per character | 7 |
Xon character | 11 |
Xoff character | 13 |
EOT | 03 |
Leader/trailer | N |
EOB | CRLF |
Timeout | 60 |
Format | Punch tape format |
Set the following parameters on the PC
Serial port tab
Machine name | Siemens - Sinumerik 840D |
Serial port | COM2 (or any free COM port) |
Baud | 9600 |
Data bits | 7 |
Parity | Even |
Stop bits | 2 |
Data flow control tab
Use DTR | False |
Use RTS | True |
Require DSR | False |
Require CTS | True |
Set RTS | False |
Set DTR | False |
Software flowcontrol | None |
Xon char | #11 |
Xoff char | #13 |
Data exchange format tab
Format mode | Uniform |
Format parameters | Program start: %
Program end: M30
Line start:
Line end: #0D#0A
Skip lines: ;
Ignore characters: No characters for remove
Remove blank lines: Yes
Program name prefix: MPF
Program starting characters in the file: No
Program ending characters in the file: Yes |
Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Go to Index page
Siemens - Sinumerik 810T
Siemens - Sinumerik 840C
Siemens - Sinumerik 850M
Siemens - Sinumerik 850T
Siemens - Sinumerik 8M
If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.