DNC and CNC setting for Siemens - Sinumerik 802D

Set the following parameters on the machine

Device	RTS/CTS
Protocol	RTS/CTS (Hardware)
Baud rate	2400
Stop bits	2
Parity	Even
Bits per character	7
Xon character	0
Xoff character	0
EOT	0
Start with Xon	N
Confirm overwrite	N
Block end CRLF	Y
Evaluate DSR	N
Leader/trailer	N
EOB	CRLF
Timeout	N
Punch tape format	Y

Set the following parameters on the PC

Serial port tab

Machine name	Siemens - Sinumerik 802D
Serial port	COM2 (or any free COM port)
Baud	2400
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: M30 Line start: Line end: #0D#0A Skip lines: ; Ignore characters: No characters for remove Remove blank lines: Yes Program name prefix: MPF Program starting characters in the file: No Program ending characters in the file: Yes

Go to Index page
Siemens - Sinumerik 3M
Siemens - Sinumerik 3T
Siemens - Sinumerik 810M
Siemens - Sinumerik 810T
Siemens - Sinumerik 840C

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.