bg

DNC and CNC setting for Okuma - Okuma OSP 7000

These settings are for the DNC Precision software only. They may not work with other software.

Set the following parameters on the machine

Optional Parameter Word
1 (no tape leader/trailer)0
34 (time before alarm)30
39 (baud rate)4800
44 (punch device)0
45 (input device)0
46 (output device)0
54 (read device)1
57 (time before alarm)90
Optional Parameter Bit #1 - 0000 1011
1.0 (Auto parity check: yes)1
1.1 (ISO code: yes)1
1.2 (Tape vertical check: no)0
1.3 (Delimiter %)1
1.4 (Verify at read: no)0
1.5 (Special code read: no)0
1.6 (Special code alarm: no)0
1.7 (Special code ignored: no)0
Optional Parameter Bit #12 for Lathe - 1010 1010
12.0 (1 stop bit: yes)0
12.1 (No ready sig.: none)1
12.2 (Parity check: no)0
12.3 (Even parity: 1 - even, 0 - odd)1
12.4 (8 data bits: no)0
12.5 (DC code: yes)1
12.6 (DC code type 2: no)0
12.7 (File name read: yes)1
Input/output operations
Sending to the PCGo to the 'Edit/AUX mode', [F3] (PIP), [F2] (Punch), type file name, then [Return] or [Write]
Reading from the PCGo to the 'Edit/AUX mode', [F3] (PIP), [F1] (Read), [Return] or [Write]

Set the following parameters on the PC

Serial port tab

Machine nameOkuma - Okuma OSP 7000
Serial portCOM2 (or any free COM port)
Baud4800
Data bits7
ParityEven
Stop bits1

Data flow control tab

Use DTRFalse
Use RTSTrue
Require DSRFalse
Require CTSTrue
Set RTSFalse
Set DTRFalse
Software flowcontrolBoth
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start: %
Program end: %
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
 

Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
 

Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

Go to Index page
Okuma - Okuma OSP 5000
Okuma - Okuma OSP 5020L
Okuma - Okuma OSP-U100
Okuma - Okuma T
Omni Turn

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.