DNC and CNC setting for Leadwell
These settings are for the DNC Precision software only. They may not work with other software.
Leadwell - V20i - Machine parameters
Set the following parameters on the PC
Serial port tab
| Machine name | Leadwell - V20i |
| Serial port | COM2 (or any free COM port) |
| Baud | 4800 |
| Data bits | 8 |
| Parity | None |
| Stop bits | 1 |
Data flow control tab
| Use DTR | False |
| Use RTS | False |
| Require DSR | False |
| Require CTS | False |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | Both |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start:
Program end:
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: Yes
Program ending characters in the file: Yes |
Leadwell - V50i - DNC settings
Set the following parameters on the PC
Serial port tab
| Machine name | Leadwell - V50i |
| Serial port | COM2 (or any free COM port) |
| Baud | 9600 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | False |
| Use RTS | False |
| Require DSR | False |
| Require CTS | False |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | Both |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Data reception |
| Format parameters | Program start: %%
Program end: %%
Line start:
Line end: #0A
Skip lines:
Ignore characters: #0D
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: Yes
Program ending characters in the file: Yes |
Leadwell - V80i - NC settings
Set the following parameters on the PC
Serial port tab
| Machine name | Leadwell - V80i |
| Serial port | COM2 (or any free COM port) |
| Baud | 9600 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | False |
| Use RTS | False |
| Require DSR | False |
| Require CTS | False |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | Both |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start: %%
Program end: %%
Line start:
Line end: #0A
Skip lines:
Ignore characters: #0D
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: Yes
Program ending characters in the file: Yes |
Go to Index page
Kitamura - HX300
Indramat system 200
Maho - CNC 432 - 1000
Mazak - Fusion 640M
If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.
