DNC and CNC setting for Leadwell - V50i

Set the following parameters on the PC

Serial port tab

Machine name	Leadwell - V50i
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	False
Require DSR	False
Require CTS	False
Set RTS	False
Set DTR	False
Software flowcontrol	Both
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Data reception
Format parameters	Program start: %% Program end: %% Line start: Line end: #0A Skip lines: Ignore characters: #0D Remove blank lines: No Program name prefix: O Program starting characters in the file: Yes Program ending characters in the file: Yes

Go to Index page
Kitamura - HX300
Leadwell - V20i
Leadwell - V80i
Maho - CNC 432 - 1000
Maho - CNC 432 - 2000

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.