DNC and CNC setting for Fanuc 6T

Set the following parameters on the machine

In the 'SET' mode select manual input mode and set following parameters
INPUT DEVICE 1	1
INPUT DEVICE 2	1
INPUT UNIT	0
PUNCH CODE	1
TV CHECK	0

In the 'PARAM' mode set following parameters
#340	2
#341	2

#310,#311,#312,#313 (baud rate) = 0000 1001
Baud	Parameter value
1200	0000 0111
2400	0000 1000
4800	0000 1001
9600	0000 1010

Set the following parameters on the PC

Serial port tab

Machine name	Fanuc 6T
Serial port	COM2 (or any free COM port)
Baud	2400
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Fanuc 21T
Fanuc 6M
Fanuc MSC-516
Fanuc O-TC
Fanuc O-T

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.