DNC and CNC setting for Bosch CC320

Set the following parameters on the machine

Select device	PORT (V240.1)
Baud	DCR 9600
Status	SW control
DFS recognize	WITH LEADER WITH TRAILER
Timeout in (sec)	10

Set the following parameters on the PC

Serial port tab

Machine name	Bosch CC320
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: Program end: M30 Line start: Line end: #0D#0A Skip lines: ; Ignore characters: No characters for remove Remove blank lines: Yes Program name prefix: Program starting characters in the file: No Program ending characters in the file: Yes

Go to Index page
Autocon
Bosch CC220
Bosch alpha 3
Bridgeport - Boss 3
Bridgeport - Boss 4

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.