DNC and CNC setting for Heidenhain-CNC Pilot

Set the following parameters on the machine

Press the [Parameter] button, then select Configure, then Control direct, then Enter parameter #42 and change
Baud rate	15 (19200)
Word length	1 (7 bits)
Parity	1 (Even)
Stop bits	0 (One)
Protocol	0 (Hardware)

Set the following parameters on the PC

Serial port tab

Machine name	Heidenhain-CNC Pilot
Serial port	COM2 (or any free COM port)
Baud	19200
Data bits	7
Parity	Even
Stop bits	1

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: Program end: Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Haas Lathe
Haas Mill
Heidenhain-TNC 145
Heidenhain-TNC 150
Heidenhain-TNC 155

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.