DNC and CNC setting for Fanuc 12M

Set the following parameters on the machine

Set the 'PWE' parameter #8000 (Enable changing parameters) to ON (all bits = 1). After changing parameters below, change this value to OFF (all bits = 0).
#5001	1
#5002	2
#5003	3
#5110	4
#5111	2
#5112	9
#5120	4
#5121	2
#5122	9
#5130	4
#5131	2
#5132	9
#0010	1
#0021	1
#0022	1
#0023	1

If you want, you can change baud rate (#5112,#5122,#5132)
Baud	Parameter value
2400	8
2400	9
4800	10
9600	11

Set additional parameters #0000
Name	Value
TVC	0
CTV	1
ISP	0
NCR	0
EIA	0

Set the following parameters on the PC

Serial port tab

Machine name	Fanuc 12M
Serial port	COM2 (or any free COM port)
Baud	2400
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Go to Index page
Fanuc 10T
Fanuc 11T
Fanuc 12T
Fanuc 15M
Fanuc 15T

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.