DNC and CNC setting for Fadal VMC
These settings are for the DNC Precision software only. They may not work with other software.
Fadal VMC - Machine parameters
Set the following parameters on the PC
Serial port tab
| Machine name | Fadal VMC |
| Serial port | COM2 (or any free COM port) |
| Baud | 9600 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 1 |
Data flow control tab
| Use DTR | False |
| Use RTS | False |
| Require DSR | False |
| Require CTS | False |
| Set RTS | True |
| Set DTR | True |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start: %#0A#0D
Program end: #0A#0D#14
Line start:
Line end: #0A#0D
Skip lines: ;
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No |
Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Go to Index page
Ellison Technologies - Puma VT900
Eckelmann - Viewstar 750
Fagor 800
Fanuc 0-P
If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.
