DNC and CNC setting for Bosch
These settings are for the DNC Precision software only. They may not work with other software.
Bosch CC220 - Machine parameters
Set the following parameters on the machine
| Select device | PORT (V240.1) |
| Baud | DCR 9600 |
| Status | SW control |
| DFS recognize | WITH LEADER WITH TRAILER |
| Timeout in (sec) | 10 |
Set the following parameters on the PC
Serial port tab
| Machine name | Bosch CC220 |
| Serial port | COM2 (or any free COM port) |
| Baud | 9600 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | False |
| Use RTS | True |
| Require DSR | False |
| Require CTS | True |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start:
Program end: M30
Line start:
Line end: #0D#0A
Skip lines: ;
Ignore characters: No characters for remove
Remove blank lines: Yes
Program name prefix:
Program starting characters in the file: No
Program ending characters in the file: Yes |
Bosch CC320 - NC settings
Set the following parameters on the machine
| Select device | PORT (V240.1) |
| Baud | DCR 9600 |
| Status | SW control |
| DFS recognize | WITH LEADER WITH TRAILER |
| Timeout in (sec) | 10 |
Set the following parameters on the PC
Serial port tab
| Machine name | Bosch CC320 |
| Serial port | COM2 (or any free COM port) |
| Baud | 9600 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | False |
| Use RTS | True |
| Require DSR | False |
| Require CTS | True |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start:
Program end: M30
Line start:
Line end: #0D#0A
Skip lines: ;
Ignore characters: No characters for remove
Remove blank lines: Yes
Program name prefix:
Program starting characters in the file: No
Program ending characters in the file: Yes |
Null modem cable, with full handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Go to Index page
Autocon
Anilam Crusader II M
Bosch alpha 3
Bridgeport - Boss 3
If you connected DNC Precision to another controller that is not on this list, please send us the information so we can add it to the list.
